Split AC Uninstallation (1 AC)

About the service

Our Split AC Uninstallation for 1 AC unit is for customers who want to safely remove a Split AC from an existing location. This service covers 1 ton, 1.5 ton and 2 ton Split ACs, inverter and non inverter, for any brand.

We remove the indoor unit, outdoor unit and interconnecting pipes carefully so the AC, wall and wiring remain as safe as possible. Ideal when you are shifting, replacing with a new AC or renovating the room.

Best for.

• Removing Split AC before painting or renovation

• Shifting 1 Split AC to a new house or office

• Replacing old Split AC with a new model

• Vacating a rented flat with installed Split AC

Our process

1. Pre uninstallation check
The technician checks indoor unit mounting, outdoor unit position, pipe routing, drain line and wiring path. They also note the AC tonnage. 1 ton, 1.5 ton or 2 ton. to plan safe removal.

2. Power isolation and safety
Power is switched off from the main switch or MCB. The technician confirms that there is no live power at the AC connection before touching any wiring.

3. Pump down or gas recovery if possible
If the system is in working condition and valves are accessible, the technician may perform a pump down. This is where refrigerant is collected inside the outdoor unit before disconnecting pipes. If the unit is already gasless or badly leaking, this step may be skipped.

4. Disconnecting indoor unit and drain
Indoor unit cover is opened. Drain pipe, copper pipes and wiring are disconnected carefully. Screws and brackets are loosened. The indoor unit is removed from the wall without pulling plaster unnecessarily.

5. Disconnecting outdoor unit and pipes
Outdoor unit power and control wiring are disconnected. Copper pipes are disconnected or cut at suitable points. The outdoor unit is removed from brackets or stand and brought down safely with controlled lifting, important especially for 1.5 ton and 2 ton units.

6. Basic tidy up and handover
Pipes, indoor unit, outdoor unit, remote and loose parts are handed over to you in one place. The wall is left neat within reasonable limits. Full civil restoration is not included.

What we need from you

• Clear access to indoor and outdoor units

• MCB or switch access to cut power

• Ladder or safe access if outdoor unit is mounted at height

• If you are shifting the AC, keep basic packing material or support ready

• Inform the technician if the AC is very old, rusted or previously tampered

Our service promise

• Safe removal of 1 ton, 1.5 ton or 2 ton Split AC

• No rough pulling of indoor unit or outdoor unit

• Wiring disconnected safely and left insulated

• Honest communication if brackets, wall or fasteners are badly rusted

• Clear separation between uninstallation service and any extra civil work

Frequently asked questions

Q1. Is this service valid for 1 ton, 1.5 ton and 2 ton Split ACs
Yes. This Split AC uninstallation covers 1 ton, 1.5 ton and 2 ton units, inverter and non inverter.

Q2. Will you reinstall the AC in another location
No. This booking is only for uninstallation. You need to book Split AC Installation separately at the new location.

Q3. Will you remove wall brackets and repair walls
Outdoor and indoor brackets may be loosened if required. Full wall repair, plaster work or painting is not part of this service.

Q4. What happens to the gas in the AC during uninstallation
If the system is healthy and valves allow, the technician can pump down refrigerant into the outdoor unit before disconnecting. If the unit was already leaking or dead, gas may not be recoverable.

Q5. How long does uninstallation of 1 Split AC take
Normally 30 to 60 minutes, depending on height, routing and rust condition.